ThunderMax 2007 - 2009 Sportster® Models
ThunderMax 309-460 ECM for 2007–2009 Sportster® Models
For EFI-equipped 2007–2009 Harley-Davidson® Sportster models.
Replace your factory engine control module with ThunderMax EFI management and AutoTune technology. The 309-460 combines a replacement ECM with wide-band oxygen sensors to monitor exhaust oxygen and adjust fueling as you ride.
How AutoTune works
Select and load a basemap suited to your motorcycle’s engine, exhaust, and other modifications. After installation and initial setup, AutoTune uses oxygen sensor feedback to make ongoing air/fuel ratio corrections.
The basemap provides your starting calibration. AutoTune refines fueling from that starting point as you ride.
Key features
- Complete replacement ECM: Replaces the factory module and connects to the motorcycle’s wiring harness.
- Wide-band AutoTune: Uses 18 mm oxygen sensors to monitor exhaust oxygen and make fueling corrections.
- Barometric compensation: A built-in sensor accounts for changes in altitude and ambient air pressure.
- Adjustable settings: ThunderMax software provides access to air/fuel targets, ignition timing, idle speed, rev limits, speedometer calibration, and other tuning parameters.
- Diagnostics and data logging: Monitor engine information and record operating data to support troubleshooting.
- U.S. engineering and support: Engineered, built, and supported in the USA.
What’s included
- ThunderMax ECM with AutoTune
- Wide-band oxygen sensors
- Plug-in harness
- USB communication cable
Check your exhaust before ordering
ThunderMax requires compatible 18 mm oxygen sensor ports in the exhaust head pipes. Verify that your exhaust has suitable ports before installation.
If your exhaust has smaller ports or no suitable sensor ports, modifications may be required. Weld-in sensor bungs are not included.
Installation and setup
Review the application-specific installation instructions before beginning. Installation includes replacing the factory ECM, fitting the oxygen sensors, and completing the software setup.
Download ThunderMax software · View installation documents
This product is intended for "RACE READY" vehicles only and is not for sale or use on vehicles otherwise subject to emission control requirements. In the state of California, this product should not be used on any vehicle that is registered for use on public roads. Please view the ThunderMax 50 application guide for "STREET APPROVED" & ARB compliant products.