Home Docs Software & Setup

ThunderMax Hill Assist / Vehicle Hold Control

Updated on Nov 17, 2026

Hill Assist, also called Hill Hold Control, is an optional function available on select Harley-Davidson® models. When stopped on an incline, the system briefly holds brake pressure after the rider releases the lever to prevent the motorcycle from rolling backward.

On stock motorcycles, enabling the feature typically requires a dealership flash. With ThunderMax installed, the source guide describes activating the feature through Basic Settings, provided the required Hill Assist / Neutral Safety add-on switch is installed.

View / Download the Hill Assist Guide - PDF

On this page

Before you begin

  • Confirm the motorcycle has the required Hill Assist / Neutral Safety add-on switch installed.
  • Install the latest version of TMax Tuner Software.
  • Confirm the ThunderMax module is linked and communicating.
  • The Vehicle Hold Control kit must be purchased separately from a local dealer if it was not fitted at the factory.

Vehicle Hold Control kit shown in the Hill Assist guide

Vehicle Hold Control kit shown in the Hill Assist guide

Watch the Hill Assist / Vehicle Hold Control video

Watch Hill Assist / Vehicle Hold Control - TMax Tech Tips

View / Download the video QR code - PDF

How the function works

Hill Assist relies on brake-pressure sensors, incline detection and gear-position inputs. It maintains brake pressure briefly after stopping on a hill, allowing time to apply throttle and pull away.

ThunderMax does not alter brake logic or perform Harley-Davidson® proprietary dealer flashes. It toggles the configuration value inside the ThunderMax module so the module can recognize and use the installed hardware.

Step 1: Connect to the motorcycle

Plug your ThunderMax communication cable into the ECM and laptop. Open TMax Tuner Software on a Windows-based PC. If needed, visit ThunderMax software downloads. Turn the ignition switch ON. When the Link tab turns green, the ECM is communicating with the software.

Step 2: Read module maps and settings

From the main menu, select File > Read Module Maps and Settings. Allow the map to load.

File menu showing Read Module Maps and Settings

File menu showing Read Module Maps and Settings

Step 3: Open Basic Settings

At the bottom of the left-hand menu tree, select Module Configuration, then Basic Settings.

Module Configuration and Basic Settings in TMax Tuner

Module Configuration and Basic Settings in TMax Tuner

Step 4: Locate Kick Stand Enable

In Basic Settings, locate the field named Kick Stand Enable. This is the exact setting specified in the Hill Assist v1.8 guide.

Basic Settings with Kick Stand Enable highlighted

Basic Settings with Kick Stand Enable highlighted

Step 5: Enable and write the setting

Open Kick Stand Enable. When the dialog appears, change the value from 0 to 1 and click OK.

Click Write Module Settings at the bottom of Basic Settings to write the updated configuration to the ThunderMax module. Unlink and disconnect.

Kick Stand Enable dialog: set the value to 1, then write module settings

Kick Stand Enable dialog: set the value to 1, then write module settings

Need help?

Contact ThunderMax technical support or email support@thunder-max.com with any questions.

Based on the ThunderMax “Hill Assist Add-on” guide, version 1.8, dated October 27, 2026.