Home Docs Tuning & AutoTune

ThunderMax Launch Control (Two-Step)

Updated on Nov 17, 2026

ThunderMax Launch Control, also called Two-Step, is a performance feature designed strictly for closed-course drag racing. It holds the engine at a preset staging RPM to provide a stable starting point for a competitive launch.

The function momentarily takes over RPM control when the clutch is held in and the throttle is snapped wide open from a complete stop. It provides repeatable staging RPM; tire preparation, traction and clutch control remain the rider’s responsibility.

View / Download the Launch Control Guide - PDF

On this page

Requirements and use restrictions

  • Closed-course drag racing only.
  • ThunderMax module firmware v6.9 or later. The guide directs users to run the latest TMax firmware.
  • An OEM clutch switch, found on most 2007-and-newer Harley-Davidson® models.
  • The motorcycle must be fully stopped: Launch Mode engages only at 0 mph. Any wheel movement deactivates the system.

Launch Control does not replace proper racing technique.

Watch the Launch Control video

Watch Launch Control - TMax Tech Tips

View / Download the video QR code - PDF

Step 1: Connect to the motorcycle

Plug your ThunderMax communication cable into the ECM and laptop. Open TMax Tuner Software on a Windows-based PC. If needed, visit ThunderMax software downloads. Turn the ignition switch ON. When the Link tab turns green, the ECM is communicating with the software.

Step 2: Read module maps and settings

Select File > Read Module Maps and Settings from the main menu. Allow the map to load.

File menu showing Read Module Maps and Settings

File menu showing Read Module Maps and Settings

Step 3: Open Basic Settings

At the bottom of the left-hand menu tree, select Module Configuration > Basic Settings.

Module Configuration and Basic Settings in TMax Tuner

Module Configuration and Basic Settings in TMax Tuner

Step 4: Select Drag Race Two-Step RPM

Locate Drag Race Two-Step RPM in Basic Settings. Choose the RPM at which the engine will be held during staging.

Basic Settings with Drag Race Two-Step RPM highlighted

Basic Settings with Drag Race Two-Step RPM highlighted

Step 5: Enter the RPM and write settings

Enter the desired RPM and confirm your choice. Write the updated settings back to the module so the configuration is stored and ready for use.

Drag Race Two-Step RPM dialog for entering the desired staging RPM

Drag Race Two-Step RPM dialog for entering the desired staging RPM

Using Launch Control

  1. With the motorcycle fully stopped, pull in the clutch lever firmly.
  2. Quickly snap the throttle to wide open. The engine will be held at the programmed RPM rather than revving freely.
  3. When staged and ready, release the clutch with authority. As the motorcycle moves, ThunderMax exits Launch Mode and resumes normal RPM control.

Important: Launch Mode engages only at 0 mph. Any wheel movement deactivates it.

Choosing a launch RPM

The ideal RPM varies by engine build. Higher-compression or high-flow combinations may require a higher RPM, while stock engines may benefit from a lower setting. The guide encourages dealers to verify the selection through test launches and customer feedback.

Need help?

Contact ThunderMax technical support or email support@thunder-max.com with any questions.

Based on the ThunderMax “Launch Control” guide, version 1.7, dated October 27, 2026.